Radiographic Testing
- • Gamma ray – (Ir-192, Co-60, & Se-75) & X-rays
- • Small Controlled Area Radiography (SCAR) / Close Proximity System (CPS)
- • Digitization of radiographs facilitating permanent storage, remote viewing & Image processing for diagnosis
- • Computed Radiography with Ir-192, Co-60, Se-75, X-rays (CR can also be performed with SCAR/CPR system
Ultrasonic Testing
- • Flaw detection on raw materials, plates, forgings, castings
- • Weld test using longitudinal angle, creep & shear wave probes
- • UT – TOFD, PAUT
- • Thickness Measurement
- • Special probes to measure thickness on 10 mm OD tubes
- • Thickness of thin materials min 0.6 mm
- • Through paint thickness on steel measurement possible
- • Thickness measurement on hot surfaces up to 6000 C
- • Bond Testing
- • UT ‘A’ scan continuous recording facility
Magnetic Particle Testing (Wet & Dry - Fluorescent & Non - Fluorescent)
- • Prod type (Up to 8000 Amps – Coils, Central Conductor, Head shots)
- • Electro Magnetic yoke
- • Permanent Magnet
Liquid Penetrant Testing (Fluorescent & Non – Fluorescent)
Hardness Testing
- • Poldy Hardness Measurement for Metals
- • Non indenting type Hardness Measurement for Metals
- • Hardness Measurement of Rubber
Alloy Analyzer – PMI by XRF
Ferrite testing
- • Austenitic & Duplex materials
Paint Thickness Measurement
Boroscope with video recording
Leak Detection
- • Helium leak detection – Mass spectrometer
- • (Detectable leak rate - Pressure vacuum 10-2 to 10-11 cc/sec.)
- • (Detectable leak rate - Vacuum method 10-4 to 10-10 cc/sec.)
- • (Detectable leak rate - Pressure method 10-1 to 10-7 cc/sec.)
- • Ultrasonic Leak Detection to detect gross leak from the system
- • (Detectable leak rate 10-1 to 10-2 cc/sec.)
- • Vacuum Leak Detection for tank bottom plates etc
- • (Detectable leak rate 10-1 to 10-3 cc/sec.)
- • Halogen Leak detection to locate gross leaks
- • (Detectable leak rate 10-1 to 10-8 cc/sec.)
- • Pneumatic leak detection to test pressure leaks
Repair & Servicing of NDT Equipments
Servicing & Maintenance of NDT Instruments is an important aspect for the success of NDT operations
It is quite unusual for an equipment to be used consistently without needing repair. Malfunction includes equipment not operating in a safe manner, not operating at all, not functioning normally. We repair properly and on timely basis
It is essential in the NDT operations to complete the expected output within time schedule. This is possible. If all equipment’s are timely serviced & maintained in systematic manner including calibrations, operation becomes effective.
We also offer preventative maintenance contracts to ensure a customer’s equipment is both calibrated and operating at peak performance